Specifications & Features: 180W Per Port for 360 Watts Max CHARGE Output 0.1A to 10.0A max CHARGE Current in 0.1A steps 50W Per Port DISCHARGE with 10A Max Current STORE MODE allows fast and simple charge/discharge to 60% capacity for proper storage of Lithium Batteries = longer battery life. Charges/Discharges 1 to 6 cells Lithium Polymer Batteries Per Port (3.7V/cell nominal types) Charges/Discharges 1 to 6 cells Lithium Ion Batteries Per Port (3.6V/cell nominal types) Charges/Discharges 1 to 6 LiFePO4 (A123) cells (LiFePO4 3.3V/cell nominal, A123 3.3v support) Charges/Discharges/Cycles 1-16 cell NiCd/Ni-MH in three modes: Normal, Linear, and Automatic Charges/Discharges 1~12 cell Lead Acid Batteries (Pb, 2V/cell) Allows Lithium-Type batteries to 50,000mAh and PB (lead/acid) batteries to 100Ah capacity Two built -in Hyperion LBA10/300 Balancers with 10A max rating and 300mA max balance rate/cell TCS - Terminal Capacity Selection Rich Data Displays during and after charging and balancing PC Port for Data Logging and Firmware upgrades Temperature Sensor Ports & Temp Stop settings* Wide Voltage Input Range 11v~28v for higher efficiency when charging high-voltage packs, and compatibility with a wider selection of AC/DC power supplies Power Supply Amperage Control to allow reliable charging with lower-output power supplies Power Supply Voltage Control (PS Load Control) works in concert with Amperage control to insure the charger does not overload your power supply Adjustable Power Sharing % between Outputs Input Cable with 4mm Male Connectors + Clamps Output Cable Set Included, with 4mm Connectors Two, Integral, Thermostat-Controlled Cooling Fans Rugged Aluminum Case with Insulating End Caps 2-Line, 16-Character, Yellow Backlit LCD Data Display. Highly visible in all conditions Total of 20 User-definable Memory Positions Firmware upgradable via Win PC **
* Temp sensors available separate: #HP-EOSTMPSEN or EOS1210i-SEN ** Firmware upgrades require USB Adapter #HP-TI-PRGUSB and harness #HP-EOS06-PCCBL. Firmware upgrades will only become available if and when improvements are identified in future.